TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

KD P. [ CALL I 2 0 0 ]
22.79 KDP. [CALLI 200]
FUNCTION
Loads, dumps, and starts the KMC-ll (KS systems only) .
CALLING SEQUENCE:
MOVE ac, [XWD len,addr]
KDP. ac,
error return
skip return
addr:
EXP fcn-code
argument 1
argument 2
argument 3
In the calling sequence, the program supplies the following variables:
o
len is the length of the argument block.
o addr is location of the argument block. At addr, store the
function code (fcn-code). The remainder--oI the argument
block depends on the function to be performed.
The function codes are:
Code
Symbol
Meaning
1 .KDPKN
Returns in argument 1 the number of KMC-lls on the
system.
2 .KDPDN
Returns in argument 2 the count of DUP-lls on
KMC that you specify in argument 1.
the
3 .KDPSS
4 .KDPHA
Returns in argument 2 the status of KMC
in argument 1.
Halts the KMC-ll specified in argument 1.
specified
5 . KDPMC
6 .KDPST
7 .KDPRE
10 .KDPWR
101 .KDLRS
102 .KDLHA
Master-clears the KMC specified in argument 1 .
Starts the KMC specified in argument 1.
Reads the CRAM location from the KMC specified in
argument 1 and pointed to by the address in
argument 2. The CRAM location is stored in
argument 3.
Writes in CRAM location from the KMC specified in
argument 1, at the address specified in argument
2, from the value stored in argument 3.
Reads line status of KMC specified in argument 1,
on line of DUP specified in argument 2. The line
status is returned in the address pointed to by
argument 3. Argument 3 must be specified as
[len, ,addr] , where len is the length and addr is
the address of the block where status is to be
stored.
Stops DDCMP on a line specified by the KMC in
argument 1 and the DUP in argument 2.
22-202