TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

TSK. [CALLI 177]
5 .TKFWT
Puts the link into the wait state. If the link is
in either the .TKSID or .TKSOK state, the monitor
takes the skip return immediately. The monitor
performs the following for those links in the
other states:
State
.TKSCI
.TKSCC
.TKSDC
Function
Waits for a transition to the .TKSOK
state and then returns.
Waits for a transition to either the
.TKSOK or .TKSID states, then returns.
Waits for a transition to .TKSID and
then returns.
6 .TKFOT
7 .TKFIN
10 .TKFRX
Performs output with control of message
disassembly. This function is valid only for
links in the .TKSOK state. This function performs
an OUT monitor calIon the specified channel. If
the OUT is successful, the contents of the buffer
will be sent without an EOF bit. If unsuccessful,
the monitor places error code TKUDW% in the ac and
returns the device status word in arg1.
Performs input with message reassembly. This
function is valid only for those links in the
.TKSOK state. It performs an IN monitor calIon
the specified channel. If the IN is successful
(non-skip return), and UU.DMR was not set on the
OPEN, the monitor reads the message as one entire
buffer and takes a skip return. If UU.DMR was
set, the message is read without reassembly. If
the IN fails, the monitor places error code TKUDW%
in the ac and stores the device status word in
ac+1.
Returns the status of the link in arg1 (see .TKFRS
for a list of codes) and the "segment size," or
the maximum message size, in arg2. Note that the
segment size is only returned if the link is in
"OK" state (. TKSOK) .
SKIP RETURN
The specified function has been performed.
22-456