TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

NODE. [CALLI 157]
17 ND.CTJ Returns the station control job number.
20 ND.OPR Returns the terminal number of the OPR terminal.
21 ND.NVR Returns the NCL version number of the remote node.
22.108.12 FUNCTION 14 (.NDGNF)
Sets or reads the "greeting" node flag. The format of the argument
list is:
addr: EXP 2
node-number
arg
In the argument word, node-number is the number of the node for which
the "greeted" node flag is to be set and/or read. The flag may be
specified in arg and is returned in argo If the node-number is
specified as 0, the node number of the first "ungreeted" node is
returned in addr+1. This function is intended to be used by
privileged programs that perform a node-specific function to a node
when it comes on line.
SKIP RETURN
The function is performed.
ERROR RETURN
One of the following error codes is returned in the ac:
Code
Symbol
Error
1 NDIAL%
2 NDINN%
3 NDPRV%
4 NDNNA%
5 NDNLC%
6 NDTOE%
7 NDRNZ%
10 NDNND%
11 NDIOE%
12 NDNFC%
13 NDIAJ%
14 NDNMA%
15 NDTNA%
16 NDNLT%
17 NDISF%
20 NDRBS%
21 NDNUG%
22 NDILN%
23 NDADC%
Illegal argument list.
Illegal node name or node number.
Not enough privileges.
Node not available.
Job not locked in core.
Timeout error.
Reserved word is not zero.
Channel not initialized or not a network device.
I/O error occurred. The left half of ac contains
I/O status bits. For a list of I/O status bits,
see Volume 1.
No free core.
In use by another job.
No message available.
Terminal not available.
Not a legal terminal.
Illegal sub-function.
Receive buffer too small.
No ungreeted nodes.
Illegal line number in station-control message.
Address check performed while reading or writing
arguments.
22-266