TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

SETUUO [CALLI 75]
34
.STPRV
Sets the privilege and capability words.
calling sequence for the .STPRV function is:
The
MOVE ac, [XWO .STPRV,arglst]
SETUUO ac,
arglst: XWO O,subfcncode
argument
subfcncode is one of the following subfunction
codes:
Code
Symbol
Subfunction
0 . STCPW
1 .STCPS
2 .STCPC
3 . STCCW
4 .STCCS
5 .STCCC
Sets entire privilege word .
Sets specified bits of privilege
word.
Clears specified bits of
privilege word.
Sets entire capability word .
Sets specified bits of capability
word.
Clears specified bits of
capability word.
NOTE
You can always clear bits in the privilege word.
However, you can set only those bits in the privilege
word that are set in the c~pability word, unless you
are a privileged job.
35
.STBSN
Sets batch stream number (settable only once per
instance) .
36
.STWTO
Sets write-to-operator values.
Table .GTOBI.
Refer
to GETTAB
37
.STCON
Sets CPU up/down status. To control the CPU
up/down status, set the appropriate bits in the
argument, from the following list:
Bit
18
19
Symbol
ST.URE
ST.USU
Function
Remove CPU from system.
Suspend the CPU.
40
.STCSB
If both Bits 18 and 19 are clear, the CPU is added
to the configuration.
The CPU number must be stored in Bits 33-35 of the
argument.
Sets or clears cache bits. The cache can be
enabled or disabled for the monitor's low segment
by setting the argument to 1 to enable cache, or 0
to disable cache.
41
.STFPS
Sets or clears
(unsupported) .
floating point simulation
22-393