TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

JOBSTS [CALLI 61]
8
9-10
11
JB.UBK
JB.UNE
The terminal device is in "break on all
characters" mode. This characteristic can be set
using the TRMOP., OPEN, or FILOP. UUOs.
Reserved for use by DIGITAL.
The terminal device is in "no echo" mode. This
characteristic can be set using the TRMOP., OPEN,
or FILOP. UUOs.
12
JB.UTO
The terminal is in
other words, the
terminal output.
terminal output
job is blocked
state.
waiting
In
for
13
14
15
16-26
JB.UCC
JB.UNT
JB.UHI
The terminal characteristics have changed since
last JOBSTS.
The terminal connected to the pseudo-terminal has
used SET HOST to connect to another system.
The terminal is HIBERing for input. If a program
such as OPR or MIC is running under batch, and
JB.UHI is set, the job will awaken on input to the
terminal. (Refer to the HB.DIN bit in the HIBER
monitor call.)
Reserved for use by DIGITAL.
27-35
JB. UJN
Bit mask to contain job number
assigned) .
(0 if none
Since JB.UOA will be set if any output is pending, but JB.UTO will be
set if the output buffer for the terminal is full, you can make each
INPUT UUO transfer more data, by testing for JB.UTO before JB.UOA,
then doing an INPUT for a PTY.
ERROR RETUR...'"\I
One of the following occurred:
o
o
The specified job number or channel number is invalid.
There was no terminal on the specified channel.
22-201