TOPS-10 Monitor Calls Manual Volume 2 AA-K039D ... - Trailing-Edge

CMAND. [CALLI 211]
On a successful skip return, the argument block appears as:
Word
o
1
n
Symbol
.CMSIZ
.CMNAM
Contents
Length of returned list
First command in the list
Remaining commands in the list
The monitor returns, in .CMSIZ, the total number of defined commands.
The command names are returned starting at .CMNAM. If the reserved
block is not long enough, the list of command names is limited to the
reserved space.
22 . 14 .5 FUNCTION 4 (. CMRET)
Returns information about a command.
list as:
You must
include the argument
Word
o
1
Symbol
Contents
.CMSIZ Length of argument list
.CMCNM Command name for which information is to be
returned.
In this argument list, specify the length of the block to be returned
in .CMSIZ, and the name of the defined command for which information
is desired, in .CMCNM. The information is returned in the form of a
command block (same as argument list for .CMINT), for the command
name.
22.14.6 FUNCTION 5 (.CMDMP)
Dumps the entire command definition data base.
following argument list:
This function uses the
Word
Symbol
Contents
o
1-n
.CMSIZ
Length of argument list
BLOCK length-1 to reserve
information.
space to return
After the call returns successfully, a list
for defined commands will be returned
Function 0 (.CMINT) for the format of the
Note that the last command block will be
indicate the end of the commarid list.
of all the command blocks
starting at Word 1. See
returned command blocks.
followed by a zero word to
SKIP RETURN
The state of a return from CMAND. UUO is described for each
listed above.
function
22-31