Denon AVR-3313 Manual - Audio Products Australia
Denon AVR-3313 Manual - Audio Products Australia
Denon AVR-3313 Manual - Audio Products Australia
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Set up speakers (Audyssey® Setup)<br />
Measurement (2nd – 8th)<br />
• In this step, you will perform measurements at multiple positions<br />
(two to eight positions) other than the main listening position.<br />
• Just one position can be measured but measuring multiple positions<br />
increases the accuracy of the correction of acoustic distortion within<br />
the listening area.<br />
Move the setup microphone to<br />
10 position 2, select “Continue”,<br />
and then press ENTER.<br />
The measurement of the second<br />
position starts. Measurements can be<br />
made in up to eight positions.<br />
Audyssey Setup<br />
Place the microphone at ear level at the 2nd listening position,<br />
then select “Continue”...<br />
Repeat step 10, measuring positions 3 to 8.<br />
11 When measurement of position 8 is completed, a<br />
“Measurements finished.” message is displayed.<br />
Audyssey Setup<br />
Measurements finished.<br />
Calculation<br />
Repeat Last Test<br />
Calculation<br />
Select “Calculation” and then press ENTER.<br />
12 Measuring results are analyzed, and the frequency response of<br />
each speaker in the listening room is determined.<br />
Audyssey Setup<br />
Calibration completed! Now calculating...Please wait.<br />
• Analysis takes several minutes to complete. The more speakers<br />
and measurement positions that there are, the more time it takes<br />
to perform the analysis.<br />
50%<br />
Continue<br />
Calculation<br />
Audyssey Setup<br />
Place the microphone at ear level at the 3rd listening position,<br />
then select “Continue”...<br />
Continue<br />
Calculation<br />
Repeat Last Test<br />
• To skip measuring the third and subsequent listening position, use<br />
ui to select “Calculation” and press ENTER to proceed to step<br />
13.<br />
• To measure the second position again, use ui to select “Repeat<br />
Last Test” and press ENTER.<br />
32