Mplus Users Guide v6.. - Muthén & Muthén

CHAPTER 16DIFFTEST = deriv.dat;where deriv.dat is the name of the data set that contains the derivativesfrom the H1 analysis that were saved using the DIFFTEST option of theSAVEDATA command when the H1 model was estimated.MULTIPLIERThe MULTIPLIER option is used with the JACKKNIFE setting of theRESPE option when replicate weights are used in the analysis to providemultiplier values needed for the computation of standard errors. TheMULTIPLIER option is specified as follows:MULTIPLIER = multiplier.dat;where multiplier.dat is the name of the data set that contains themultiplier values needed for the computation of standard errors.COVERAGEThe COVERAGE option is used with missing data to specify theminimum acceptable covariance coverage value for the unrestricted H1model. The default value is .10 which means that if all variables andpairs of variables have data for at least ten percent of the sample, themodel will be estimated. Following is an example of how to use theCOVERAGE option:COVERAGE = .05;where .05 is the minimum acceptable covariance coverage value.ADDFREQUENCYThe ADDFREQUENCY option is used to specify a value that is dividedby the sample size and added to each cell with zero frequency in the twowaytables that are used in categorical data analysis. As the default, 0.5divided by the sample size is added to each cell with zero frequency.The ADDFREQUENCY option is specified as follows:ADDFREQUENCY = 0;554