Operator's Manual - Sirona - Technical Documentation

DesignTrimming the antagonistSirona Dental Systems GmbHOperator's ManualBy clicking the "Trim" button, you can simultaneously show or hide all imageregions.NOTICEShowing and hiding the preparationShowing and hiding the preparationIf the preparation was not trimmed, you can use the "Trim" button to showand hide the entire preparation, e.g. for editing the proximal surface of therestoration.7.2 Trimming the antagonistIntroductionThis design step can be used in the following, if an optical impression of theantagonist exists."Restoration"CEREC 3D"Design technique""Crown" ● "Biogeneric"● "Biogeneric reference"● "Articulation""Inlay, Onlay, Partial crown" ● "Biogeneric"DescriptionAfter you have trimmed the preparation, you can hide the image regions of theantagonist.Correct trimming of the antagonist is very important for improvement of thesettling results.This new design step will automatically be skipped if no optical impressionhas been scanned.emptyInstructionsHiding image regionsAntagonist transparentIn this design step, the antagonist is displayed slightly transparent and thepreparation is simultaneously displayed. This makes it easier for you to recognizewhere it makes the most sense to trim the antagonist.Draw a closed line (e.g. around the impression of the antagonist/registration):1. Set the starting point with a double-click.2. Click to set further points.3. Set the line end by double-clicking.The area outside the line is hidden.59 56 458 D 3344106 D 3344.208.05.14.02 04.2011