Operator's Manual - Sirona - Technical Documentation

DesignEntering the preparation marginSirona Dental Systems GmbHOperator's ManualNOTICEMoving not possible during the drawing processSince the last "drawing click" can be undone by clicking with the right mousebutton, it is not possible to move the 3D model while drawing (since this isdone by pressing and holding down the right mouse button).Notes on the preparation marginDuring the entry of the preparation margin, you can rotate the 3D display ofthe preparation.The preparation margin must always form a closed line.You can edit the preparation margin after entering the last line.7.3.2 Entering the preparation marginEntering the preparation margin1. Start the entry by double-clicking anywhere on the preparation margin.2. Move the cursor along the preparation margin.NOTICEAutomatic edge detectionTo support the automatic edge detection, click anywhere near the margin onthe raised side. There is an automatic correction when the next point is set.3. Continue this procedure until you are back at the starting point.4. Conclude the entry by double-clicking the starting point.59 56 458 D 3344108 D 3344.208.05.14.02 04.2011