Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH User interface in Master ModeOperator's Manual5.4.5.3 Smoothing an areaYou can also smoothen a previously defined area with the "Shape" tool.1. Start to draw a line by double-clicking the restoration.2. Draw the area inside which you want to smoothen the surface by clicking.NOTICEStarting point and end pointIndividual points may lie on the residual tooth, but the starting and end pointmust be on the restoration.3. Set the line end by double-clicking the starting point.4. Activate the smoothing function by pressing the spacebar. The surface inside the area is smoothed.5.4.6 Positioning tool (Position)DescriptionBy clicking the "Position" tool, you can activate the positioning function.båÖäáëÜWith this function you can move the entire restoration (or the selected element)in the following directions:●●●mesio-distalbucco-lingualocclusal-cervicalThe restoration can be positioned in two ways:●●step by step, by repeatedly clicking a segment of the circlecontinuously, by keeping a circle segment pressed.ExitTo exit the positioning tool, click the highlighted button marked "Position".When you exit the positioning tool, the connection to the preparation margin(base line) is restored.59 56 458 D 3344D 3344.208.05.14.02 04.2011 45