Operator's Manual - Sirona - Technical Documentation

MillingMilling previewSirona Dental Systems GmbHOperator's Manual8 Milling8.1 Milling previewAfter having finished the design of the restoration, you can activate the millingpreview by clicking on the "Next" icon.The restoration is shown in the viewer exactly as it will be machined by themilling unit.You can also use the "Form", "Drop", and "Shape" free forming tools in themilling preview.If you click the "Undo" icon inside a tool once, this causes all of the changesmade with this tool to be reversed.If you click the "Undo" icon a second time, you quit the milling preview andreturn to the design mode.ChangesCAUTIONThe changes you have made in the milling preview mode using the "Form","Drop", and "Shape" tools are then lost.you can select and change the following:●●●●Selecting the milling unitBlock visualizationChange of sprue location"Sinter Support"8.1.1 Milling unit selectionyou can set the following:● Select the milling unit with which you would like to mill the restoration("Select" button):– MC XL– CEREC 3– inLab● The program automatically displays the milling preview according to themilling instruments you have selected for the respective milling unit.● The Endo mode is automatically activated for crowns in the anterior toothregion and for veneers.● You can activate the Endo mode for any type of restoration ("Endo" checkbox).● When using an MC XL milling unit with 4 motors, you can select the burset for which the floor simulation is to be reconstructed and displayed.59 56 458 D 3344114 D 3344.208.05.14.02 04.2011