Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH User interface in Master ModeOperator's Manual5.7.3.3.1.3 Add manuallyUnits which cannot be operated at the maximum speed of 115,200 baud mustbe entered manually. This normally proves necessary only when longer cableconnections or certain radio modules (e.g. Futaba, 19,200 baud) are used.Using the "Add manually" button, you can add these devices and enter the followinginformation in the dialog box which then appears:● Description● Interface● Baud (transmission speed)5.7.3.3.1.4 RemoveA connected device can be removed by clicking the "Remove" button in themain configuration dialog. The calibration data are not deleted in this case. Ifthe device is added again, the corresponding calibration data will be reloadedand used.5.7.3.3.1.5 Configuration (CEREC 3)Graphic device configurationbåÖäáëÜ5.7.3.3.1.5.1 ScannerCEREC device configurationDescriptionVia the "Configure" button, you can subsequently edit the name and connectionsettings and configure various parameters.● "inLab gearhead installed"● "Large watertank"● "Scanner"For a CEREC 3 milling unit with an integrated scanner, a check mark must beplaced in the checkbox front of "Scanner" .emptyRetrofitting CEREC 3Retrofitting (CEREC 3)If the scanner (optional, order no. 58 33 707) is retrofitted, your service engineermust place a check mark in the box in front of "Scanner" .59 56 458 D 3344D 3344.208.05.14.02 04.2011 67