Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH Restoration types and design techniquesOperator's Manual10.3.3.8 Making a proximal contactMOD inlay with antagonist image for tooth 16 inLab/CERECChanging the contact surfaces1. Activate the contact surfaces by clicking the "Contact" button (see "Showing/hidingthe contact to the neighboring tooth (Contact)" [ ➙ 31]).2. If red penetration areas are present, they can be eliminated using the"Design" tools (see "Design window" [ ➙ 37]).3. After the design is finished, click the icon marked "Next".båÖäáëÜ10.3.3.9 Examining the milling previewMOD inlay with antagonist image for tooth 16 inLab/CEREC10.3.3.10 MillingMilling previewInstructionsThe finished restoration is displayed in the milling preview (see ".Milling preview[ ➙ 114]“).1. Inspect the restoration.2. Select the desired milling mode.3. Set the sprue location on a flat, convexly curved side.Instructions1. If you are satisfied with the restoration, click the "Mill" icon (see "Mill" [ ➙114]).2. Start the milling process (see also Operating Instructions of the millingunit).59 56 458 D 3344D 3344.208.05.14.02 04.2011 133