Operator's Manual - Sirona - Technical Documentation

Restoration types and design techniquesBiogeneric reference (only in Master Mode)Sirona Dental Systems GmbHOperator's Manual10.4.4.8 Examining the milling previewCrown for tooth 26, inLab/CEREC10.4.4.9 MillingMilling simulationInstructionsThe finished restoration is displayed in the milling preview (see ".Milling preview[ ➙ 114]“).1. Inspect the restoration.2. Select the desired milling mode.3. Set the sprue location on a flat, convexly curved side.Instructions1. If you are satisfied with the restoration, click the "Mill" icon (see "Mill" [ ➙114]).2. Start the milling process (see also Operating Instructions of the millingunit).10.5 Biogeneric reference (only in Master Mode)Biogeneric reference fragmentSelect this design procedure if you wish to make a fully anatomic proposal,which is reconstructed from one of the reference teeth specified by yourselfby means of the patented biogeneric procedure. This reference tooth must beacquired on a separate basis in the "Occlusion" image field.This technique can be used for inlays, onlays, partial crowns, crowns, andbridges.✔ You have selected a patient from the database or created a new patient.1. In the New dialog box, select "Biogeneric reference" as the design procedure.The bite registration technology "Buccal scan" is not available toyou.2. As usual, take acquisitions of the preparation.3. Take an optical impression of a reference tooth in the "Occlusion" imagefield. The tooth is to be fully acquired from the occlusal direction.59 56 458 D 3344158 D 3344.208.05.14.02 04.2011