Operator's Manual - Sirona - Technical Documentation

User interface in Master ModeMenu barSirona Dental Systems GmbHOperator's Manual5.7.3.1.5 Margin thicknessPrior to milling of inlays, the margin of the restoration is thickened by the setthickness.The "Margin thickness" can be adjusted in increments of 25 µm from 0 µm to200 µm.AAMargin thickness A (exaggerated representation)5.7.3.1.6 Veneer thicknessThis parameter allows you to set the initial veneer thickness (A) for veneer restorationsusing the following design techniques:● "Biogeneric"● "Biogeneric reference"Veneer thicknessThe "Minimal thickness (Veneer)" can be adjusted in increments of 100 µmfrom 0 µm to 2000 µm.In the case of a minimum thickness below 500µm, these are referred to as thinveneers. In this case, "e.max CAD" is available as material.5.7.3.1.7 Adhesive gapDescriptionIf you find that all of your inlay restorations turn out to be too large, you cancompensate for this by modifying the adhesive gap.If you set a larger number in the "Adhesive gap" text box, the adhesive gapwill be enlarged correspondingly. The size of the adhesive gap can be variedin increments of 10 µm from 0 µm to 150 µm.NOTICEThis setting affects the calculation of the restoration.59 56 458 D 334462 D 3344.208.05.14.02 04.2011