Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH User interface in Master ModeOperator's Manual5.7.2.2 QuadrantDescription: quadrantNOTICEQuadrant restorationDuring a quadrant restoration, the software will not let you switch to a toothfrom the opposite jaw.When you switch to a tooth in the opposite quadrant of the same jaw, themodel is automatically rotated by 180° to ensure correct direction designations.With the menu item "Quadrant…" the virtual seating and opening of a secondprogram is essentially performed automatically.After this menu item is selected, the New dialog box for selecting the tooth,the restoration type and the design technique opens. The patient is accepted.This is followed by the virtual seating and start of a second CEREC 3D program.In the program running in the foreground, the old restoration is in its originalstate and could be milled, for example.The program with the virtually seated restoration is loaded in the background.It can be reached e.g. via the task bar or the task selection keys (Alt+Tab). Inthis program the dialog for centering ("Centre...") is open.båÖäáëÜNOTICESetting the insertion axisRemember to set the insertion axis correctly after drawing in the preparationmargin ("Design"/"Insertion axis...").CEREC linkSee also the example under "Quadrant restoration (in the Master mode only)"[ ➙ 159].5.7.2.3 Pre-positioning toolThis tool is available to you directly following automatic calculation of the initialsuggestion of a fully anatomic crown or bridge restoration in the case of thefollowing design procedure:Design procedure for CEREC● "Biogeneric",● "Biogeneric reference",Once this tool has been activated, the automatic adjustments to the adjacentteeth and the antagonists are reverted. You can now manually adjust the restorationusing the tools of the "Design" window.59 56 458 D 3344D 3344.208.05.14.02 04.2011 57