Operator's Manual - Sirona - Technical Documentation

Restoration types and design techniquesCorrelation (in Master Mode only)Sirona Dental Systems GmbHOperator's Manual10.4.3.8 Examining the milling previewTooth 16 with fissures - Correlation - inLab10.4.3.9 MillingMilling simulationInstructionsThe finished restoration is displayed in the milling preview (see ".Milling preview[ ➙ 114]“).1. Inspect the restoration.2. Select the desired milling mode.3. Set the sprue location on a flat, convexly curved side.Instructions1. If you are satisfied with the restoration, click the "Mill" icon (see "Mill" [ ➙114]).2. Start the milling process (see also Operating Instructions of the millingunit).10.4.4 Design example of crown for tooth 2610.4.4.1 Creating a new restorationInstructions✔ You have selected a patient from the database or created a new patient.1. In the "New" dialog, select the information stated below.2. Click "OK".RangeValue"Restoration""Crown""Design technique" "Correlation"Tooth 26Crown for tooth 26 (Master/inLab)10.4.4.2 Acquiring the occlusionNOTICEObserve instructionsObserve central instruction / instructions inLabThe occlusion of the tooth to be restored must be located in the center of theimage during the acquisition. Observe the instructions under "General informationon the optical impression".Prerequisite for reconstructing occlusal surface with powdered working field1. Reconstruct the occlusal surface provisionally and check the contact situation.2. Move the arrow cursor to the icon marked "Acquire occlusion".59 56 458 D 3344154 D 3344.208.05.14.02 04.2011