Operator's Manual - Sirona - Technical Documentation

Tips and TricksService programSirona Dental Systems GmbHOperator's Manual14.5 Service program✔ The CEREC 3D program is installed.➢ Start the service program in the CEREC program group by clicking"Start"/"Programs"/"CEREC"/"Service" .Service dialogCAUTIONService functionsThe service functions are exclusively for use by authorized CEREC serviceengineers.This program area can be accessed only by authorized technical personnelwith a service password.●●●With the Yes button, you confirm the service password.Use the "No" button to quit the service program.Using the "Maintenance only" button, you can also perform a waterchange of the milling unit without having to enter a service password (alsosee the Operating Instructions for the milling unit).14.6 Frequently Asked Questions14.6.1 Database connectionThe tooth number specified by the CEREC entries (code “VC”) is not convertedin S(V)IDEXIS when the U.S. odontogram is used.14.6.2 Minimizing the programThe CEREC 3D program cannot be minimized during the milling process.14.6.3 Blurred optical impressionsMotion blurring in optical impressions (preparation or occlusion) can be recognizedby their wavy appearance. Bright or dark spots in the height image(preparation or occlusion) are also indications of motion blurring.Blurred optical impressions may produce bad milling results (holes in the restoration).The 3D camera must be held steadily until you hear an audible“click” sound.59 56 458 D 3344174 D 3344.208.05.14.02 04.2011