Operator's Manual - Sirona - Technical Documentation

User interface in Master ModeMenu barSirona Dental Systems GmbHOperator's Manual5.7.3.3 Configuration5.7.3.3.1 DevicesUnder this menu item, you can check and modify the factory-set configurations.● "Devices..."● "Acquisition system"● "Save"● "Odontogram"● "Options"Configuring graphic devicesConfiguring CEREC devicesDescriptionVia the menu item "Settings"/"Configuration"/"Devices..." all connected devices(milling units/inEos) can be displayed and configured. Several millingunits and one inEos can be managed.A green check mark next to a device denotes its active availability, e.g. thismilling unit can be selected for milling.A red cross indicates that this device cannot be selected, e.g. this milling unitis currently performing a milling operation or its calibration data are invalid.A yellow exclamation mark indicates that the current milling program must beloaded into the milling unit (see Operating Instructions for the milling unit).5.7.3.3.1.1 Refresh statusYou can use the "Refresh status" button to refresh the status display, e.g.check whether a milling unit has in the meantime finished milling.5.7.3.3.1.2 Add automaticallyThe function "Add automatically" detects any and all devices (milling units/in-Eos) connected to the PC. If a new device is detected, a dialog box for enteringthe name of the detected device automatically appears.59 56 458 D 334466 D 3344.208.05.14.02 04.2011