Operator's Manual - Sirona - Technical Documentation

Tips and TricksTechnical notesSirona Dental Systems GmbHOperator's Manual14.4.3 Problems during communication with the milling unitCommunicationIf no communication can be established with the milling unit, check the portand baud rate settings under "Settings"/"Configuration"/"Devices..."/"Configure".Radio link to milling unitUnder unfavorable radio conditions, problems can arise in the communicationwith the milling unit. Switch the radio module of the milling unit off (pull out theplug) and then back on and try again.14.4.3.1 Examples with CEREC 3 acquisition unit connectedCable connection Port=COM2 Baud rate=115200Cable connection, long Port=COM2 Baud rate=19200EU radio link Port=COM1 Baud rate=115200U.S. radio linkPort=COM1Baud rate=115200(Höft&Wessel)U.S. radio link (Futuba) Port=COM1 Baud rate=19200Japan radio link (Futuba) Port=COM1Baud rate=1920014.4.3.2 For PC/notebookCheck the "Communications Port" (interface).1. Select "Start"/"Settings"/"Control panel".System Properties2. Double-click "System".3. In "System Properties", select the "Hardware" tab and click on "DeviceManager".59 56 458 D 3344172 D 3344.208.05.14.02 04.2011