Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH User interface in Master ModeOperator's Manual5.7.3.3.5.6 Automatic acquisition (with CEREC Bluecam only)Automatic acquisition (Bluecam only)For impressions acquired with the CEREC Bluecam, you can use the "Automaticcapture" option to set the sensitivity to shaking of the automatic acquisitiontechnique. The setting options are available:● "very strict"● "strict"● "standard"● "tolerant"● "very tolerant"5.7.3.3.5.7 Use marked calibration partsTick this option if you use a blue-marked calibration part B and a blue-markedcalibration cylinder. After this, perform a complete inEos calibration (see in-Eos Operating Instructions).5.7.3.4 CalibrationIntroductionGraphicsUnder the menu option "Calibration" you can...3D camera list●calibrate the "3D camera",3D camera must be selected as the acquisition system (see chapter on“Calibrating the Bluecam/3D camera” in the Operating Instructions for theacquisition unit).båÖäáëÜNOTICECalibrating the Bluecam/3D cameraFor calibration of the Bluecam/3D camera, you will require the "Bluecam calibrationset"/"3D calibration set".The "Bluecam calibration set"/"3D calibration set" must not be powdered.Scanner list●calibrate the "Scanner" (see chapter on “Calibrating the scanner” in theOperating Instructions for the milling unit).inEos list●calibrate the "inEos" device (see chapter on "Calibrating" in the inEosBlue Operating Instructions).Milling unit list●calibrate the "Milling unit" (see chapter on “Calibrating the milling unit” inthe Operating Instructions for the milling unit).59 56 458 D 3344D 3344.208.05.14.02 04.2011 73