Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH User interface in Master ModeOperator's Manual●●by pressing the center mouse button and moving the mouse:– forward, you zoom the 3D view in– back, you zoom the 3D view outby simultaneously pressing the left mouse button and the Shift key andmoving the mouse:– forward, you zoom the 3D view in– back, you zoom the 3D view out5.3.4 Showing/hiding the neighboring teethYou can hide the neighboring teeth by clicking the "Trim" button.For the case that parts of the neighboring teeth are disturbing during input ofthe preparation margin, trimming off the disturbing parts is possible. For thispurpose, you can hide parts of the image after image acquisition (see "Trimmingthe preparation [ ➙ 105]“).You can redisplay the neighboring teeth by clicking the "Trim" button again.NOTICEShowing and hiding with the Trim buttonIf the preparation was not trimmed, you can use the "Trim" button to showand hide the entire preparation, e.g. for editing the proximal surface of therestoration.båÖäáëÜ5.3.5 Showing/hiding the contact to the neighboring tooth (Contact)You can show or hide the contact surface to the neighboring tooth by clickingthe "Contact" button.You can click on the "Contact" button to open the "Contact Options" dialogbox. 1 .You can have the appropriate proximal contact defined automatically by clikkingthe corresponding button.NOTICEHiding the neighboring teethFor better assessment of the contact surface you can hide the neighboringteeth with the "Trim" button.If you click the "Contact" button, a color scheme with the following meaningappears on the contact surfaces:1. This option can only be used for posterior tooth crowns (not for anterior toothcrowns, veneer, etc.).59 56 458 D 3344D 3344.208.05.14.02 04.2011 31