Operator's Manual - Sirona - Technical Documentation

User interface in Master ModeMenu barSirona Dental Systems GmbHOperator's Manual●●●●●"Minimal thickness (radial)""Minimal thickness (Veneer)""Adhesive gap""Spacer""Scan step width"5.7.3.1.1 Proximal contacts strengthThe CEREC 3D software automatically determines the proximal contact thickness.NOTICENo contact to the neighboring toothIf the neighboring tooth is located at a distance of more than 1mm (e.g.neighboring tooth prepared), no contact is made.The setting of the parameter "Proximal contacts strength" affects crown, inlayand onlay restorations.If you find that the contacts proposed by the software are generally too strongor too weak, you can change them via the menu "Settings"/"Parameters..."according to your requirements.If you set a higher number in the "Proximal contacts strength" text box, correspondinglymore material will be applied to the contact points.The thickness of the contact points can be adjusted in increments of 25µmbetween -200µm and 200µm.NOTICEChange only after recalculationThis setting acts only on line suggestions. A change to this setting becomeseffective only after recalculation of the suggestion.NOTICEInadequate suggestions for contact pointsThe proximal contact points are determined by the software by analyzingyour measured data. Poor quality of the acquisition data can lead to inadequatesuggestions regarding the contact points.The setting of the parameter "Proximal contacts strength" has no influence onthe design of crown and bridge frameworks.5.7.3.1.2 Occlusal contacts strengthWith this parameter you can set the contact thickness to be produced in connectionwith "Virtual grinding".The thickness of the contact points can be adjusted in increments of 25µmbetween -200µm and 200µm.59 56 458 D 334460 D 3344.208.05.14.02 04.2011