Operator's Manual - Sirona - Technical Documentation

MillingStarting the milling processSirona Dental Systems GmbHOperator's ManualCAUTIONMilling chamber doorThe milling chamber door must be closed.3. Open the milling chamber door.WARNINGRisk of injury on milling instruments!If you put your hand in the milling chamber, you could injure it on the millinginstruments.Be careful not to brush against the milling instruments with your hand.4. Insert a ceramic block of the required size and color in the spindle/workpieceaxis (also see Operating Instructions of the milling unit).CAUTIONError message during touch process!Always insert the ceramic block that you selected in the "Select block" dialogbox. Otherwise an error message will be displayed during the touch process.5. Close the milling chamber door and start the milling process (click"Start").CAUTIONDo not activate the sleep modeThe sleep mode of the PC must not be activated during the milling process.The instruments are measured automatically and milling starts.The remaining processing time is displayed continuously.The number of milled restorations is shown so that the service life of the millinginstruments still available can be estimated.CAUTIONCanceling the milling processYou can cancel the milling process at any time by pressing the "Stop" button.59 56 458 D 3344118 D 3344.208.05.14.02 04.2011