Operator's Manual - Sirona - Technical Documentation

User interface in Master ModeMenu barSirona Dental Systems GmbHOperator's ManualemptyGeneral descriptionGeneralIn the "General" group, you can select or deselect the following options:General group, CEREC● "Show all warnings and messages"●●●●"Trim preparation step active""Insertion axis step activ""Start in Master mode""Show parameter dialog"empty3D camera (camera exposure)Camera acquisitionIn the "Camera acquisition" group, you can set the following option for exposurestaken with the CEREC Bluecam:● "Automatic capture"emptyinEosinEosIn the inEos group, you can select or deselect the following options:●"Use marked calibration parts"5.7.3.3.5.1 Show all warnings and messagesIf you have hidden individual warnings (checkmark in front of "Do not displaythis warning again."), they can be displayed again by placing a checkmark infront of "Show all warnings and messages".5.7.3.3.5.2 Preparation trim step activeIf a check mark is set in front of "Trim preparation step active", you can removeimage regions before entering the preparation margin (see "Trimming thepreparation [ ➙ 105]“).If a check mark is not set in front of "Trim preparation step active", this stepwill be skipped and you can continue with trimming the antagonist (if present)or with entering the preparation margin.5.7.3.3.5.3 Insertion axis step activeIf this option is activated, you will be prompted to set the insertion axis afterdrawing in the preparation margin.5.7.3.3.5.4 Start in Master ModeIf this box is checked, the next start of CEREC 3D will be executed in "MasterMode".5.7.3.3.5.5 Display parameter dialog boxWhen this option is activated, each time a restoration is performed, the parameterdialog box will be displayed in order to check the settings.59 56 458 D 334472 D 3344.208.05.14.02 04.2011