Operator's Manual - Sirona - Technical Documentation

Sirona Dental Systems GmbH User interface in Master ModeOperator's Manual3. Click the center of the preparation to be edited.4. Click the button marked "Fix". The preparation appears in the center of the viewer and the "Centre"window closes5.7.2.5 Insertion axisWith the help of this function you can redefine the orientation of the preparation(mesial - distal, buccal - lingual) as well as the milling direction (see "Redefiningthe insertion axis" [ ➙ 109]) .5.7.2.6 Correcting an optical impressionWith the help of this function, you can remove artifacts and cut away disturbingmarginal information, e.g. on optical impressions from the image fields ofthe antagonists or of the occlusion (see "Deleting and correcting image regionsin image fields" [ ➙ 112]).5.7.3 Settings menuWith the "Settings" menu, you can adapt and change the following menuitems:● "Parameters..."● "Instruments"● "Configuration"● "Calibration"båÖäáëÜ5.7.3.1 ParametersDescriptionGraphic parametersA restoration requires some settings with regard to the milling/design process.You can make the settings for all parameters via the "Settings"/"Parameters..."menu item.The edited parameter values are saved with the restoration. If a restoration isloaded, the corresponding parameters are automatically loaded along with itand used.NOTICEFactory settingsThe unit was set up optimally during final testing at the factory.You can check the following parameters and modify them, if necessaryCEREC menu items● "Proximal contacts strength"●●●●"Occlusal contact strength""Occlusal offset""Margin thickness""Minimal thickness (occlusal)"59 56 458 D 3344D 3344.208.05.14.02 04.2011 59