Manual - Famco

Chapter 6 - Parameter Description [FU2]6.3 Function 2 Group [FU2]FU2-00: Jump to desired code #FU2► Jump code00 1Factory Default: 1Jumping directly to any parameter code can beaccomplished by entering the desired code number. Thiscode is available only with LCD keypad.FU2-01: Previous Fault History 1FU2-02: Previous Fault History 2FU2-03: Previous Fault History 3FU2-04: Previous Fault History 4FU2-05: Previous Fault History 5FU2-06: Erase Fault HistoryFU2► Last trip-101 None□□□01Factory Default: None 0FU2► Last trip-505 None0500[Fault Contents]Fault (Trip)Keypad DisplayLCD 7-SegmentOver-Current 1 Over Current 1 OCOver-Voltage Over Voltage OVExternal Trip Input A External-A EXTAEmergency Stop(Not Latched)BXBXLow-Voltage Low Voltage LVFuse Open Fuse Open FUSEGround Fault Ground Fault GFOver-Heat on Heat sink Over Heat OHElectronic Thermal Trip E-Thermal ETHOver-Load Trip Over Load OLTInverter H/W Fault- EEP Error- ADC OffsetHW-DiagHW- WDOG Error- In-Phase OpenExternal Trip Input B External-B EXTBOver-Current 2 Arm Short ASHTOption Error Option OPTOutput Phase Loss Phase Open POInverter Over-Load Inv. OLT IOLT☞ Note: There are WDOG error, EEP error, and ADCOffset for the inverter Hardware Fault, and the inverterwill not reset when H/W fault occurs. Repair the faultbefore turning on the power.☞ Note: When multiple faults occur, only the highest-levelfault will be displayed.Factory Default: None 0Related Functions:DRV-12 [Fault Display] displays currentfault status.This code displays up to five previous fault (trip) status ofthe inverter. Use the PROG, ▲ and ▼ key beforepressing the RESET key to check the fault content(s),output frequency, output current, and whether theinverter was accelerating, decelerating, or in constantspeed at the time of the fault occurred. Press the ENTkey to exit. The fault content will be stored in FU2-01through FU2-05 when the RESET key is pressed. Formore detail, please refer to Chapter 7.FU2► Erase trips06 --- No ---06Factory Default: No 0This function erases all fault histories of FU2-01 to FU-05 from the memory.099