Manual - Famco

Chapter 4 – Quick start procedures4.3 Operation using Keypad and Control Terminals4.3.1 Frequency set by External Source and Run/Stop by Keypad1. Install a potentiometer on terminals V1, VR, 5G and connect wiring as shown below left.When a ‘4 to 20mA’ current source is used as the frequency reference, use terminals I and 5G as shown below.DRV 04 must be set at V1. 1 kΩ, 1/2 WDRV 04 must be set at I.P1 P2 P3 FX RX NC VR VIJOG CM CM BX RST I FM 5GP1 P2 P3 FX RX NC VR VIJOG CM CM BX RST I FM 5G4 to 20mA signal2. Apply AC power.3. LCD: Press [▲] key to move DRV 03.7-Seg: Rotate encoder knob until ‘03’ isdisplayed.4. LCD: Press [PROG] key.7-Seg: Press [PROG/ENT] key.5. LCD: Press [▲] key one time.7-Seg: Rotate encoder knob and set at ‘0’.6. LCD: Press [ENT] key.7-Seg: Press [PROG/ENT] key.7. Confirm that the DRV 04 is set at ‘V1’.8. Press [SHIFT/ESC] key.Set the frequency by rotating thepotentiometer.DRV►T/K 0.0 A00 STP 0.00HzDRV► Drive mode03 Fx/Rx-1DRV► Drive mode03 Fx/Rx-1DRV► Drive mode03 KeypadDRV► Drive mode03 KeypadDRV► Freq mode04 V1DRV►T/V 0.0 A00 STP 60.00HzThe DRV LED is ON.The PROG/ENT LED is turned ON.The PROG/ENT LED is turned ON.The PROG/ENT LED is turned OFF.The PROG/ENT LED is turned ON.9. LCD: Press [FWD] or [REV] key.7-Seg: Press [RUN] key.The FWD or REV LED starts blinking.The RUN LED starts blinking.To change the motor runningdirection, change DRV 13 to ‘1’.54