Manual - Famco

Chapter 2 - Operation2.2.1 LCD Keypad Display2) Run/Stop Source 3) Frequency Setting Source1) Parameter group4) Output CurrentDRV▶T/K 0.0 A00 STP 0.00 Hz5) Parameter Code6) Operating Status7) Drive Output Frequency During Run,Command Frequency During StopDisplaysDescription1) Parameter Group Displays the parameter group. There are DRV, FU1, FU2, I/O, EXT, COM, APP groups.2) Run/Stop Source Displays the source of motor Run and StopK: Run/Stop using FWD, REV buttons on keypadT: Run/Stop using control terminal input FX, RXO: Run/Stop via option board3) Frequency SettingSourceDisplays the source of command frequency settingK: Frequency setting using keypadV: Frequency setting using V1 (0 ~10V) or V1 + I terminalI: Frequency setting using I (4 ~ 20mA) terminalU: Up terminal input when Up/Down operation is selectedD: Down terminal input when Up/Down operation is selectedS: Stop status when Up/Down operation is selectedO: Frequency setting via Option boardX: Frequency setting via Sub boardJ: Jog terminal input1 ~ 8: Step frequency operation* During Auto operation, 2) and 3) display the ‘sequence number/step’.4) Output Current Displays the Output Current during operation.5) Parameter Code Displays the code of a group. Use the ▲(Up), ▼(Down) key to move through 0~99 codes.6) Operating Status Displays the operation information.STP: Stop StatusFWD: During Forward operationREV: During Reverse operationDCB: During DC BrakingLOP: Loss of Reference from Option Board (DPRAM fault)LOR: Loss of Reference from Option Board (Communication network fault)LOV: Loss of Analog Frequency Reference (V1: 0~10V)LOI: Loss of Analog Frequency Reference (I: 4~20mA)LOS: Loss of Reference from Sub-Board7) Drive Output FrequencyCommand FrequencyDisplays the Output Frequency during run.Displays the Command Frequency during stop.25