Manual - Famco

Chapter 6 - Parameter Description [I/O][XCEL-L, XCEL-M, XCEL-H]By setting P1, P2 and P3 terminals to ‘XCEL-L’, ‘XCEL-M’ and ‘XCEL-H’ respectively, up to 8 different Accel andDecel times can be used. The Accel/Decel time is set inDRV-01 ~ DRV-02 and I/O-25 ~ I/O-38.The Accel/Decel time is determined by the combinationof P1, P2 and P3 terminals as shown in the followingtable.Accel/DecelTimeAccel Time-0Decel Time-0Accel Time-1Decel Time-1Accel Time-2Decel Time-2Accel Time-3Decel Time-3Accel Time-4Decel Time-4Accel Time-5Decel Time-5Accel Time-6Decel Time-6Accel Time-7Decel Time-70: OFF, 1: ONParameterCodeDRV-01DRV-02I/O-25I/O-26I/O-27I/O-28I/O-29I/O-30I/O-31I/O-32I/O-34I/O-35I/O-36I/O-37I/O-38I/O-39XCEL-H(P3)XCEL-M(P2)XCEL-L(P1)0 0 00 0 10 1 00 1 11 0 01 0 11 1 01 1 1[Dc-brake]DC Injection Braking can be activated during inverterstopped by configuring one of the multi-function inputterminals (P1, P2, P3) to ‘Dc-bake’. To activate the DCInjection Braking, close the contact on the assignedterminal while the inverter is stopped.[Exchange]Exchange is used to bypass the motor from the inverterline to commercial power or the opposite. To bypass themotor to commercial line, set the ‘Exchange’ function inmulti-function output terminal and ‘INV line’, ‘COMM line’function in multi-function output terminal. Speed searchfunction (FU2-22) is activated automatically duringexchanging operation.Forward Run/StopReverse Run/StopMCCBRSTGFXRXM1UVWFM5GM2MOTOROutput FrequencyRef.Freq.‘Exchange’Common TerminalP1P2P3CMFactory Setting:‘Speed-L’‘Speed-M’‘Speed-H’30A30CAC220V LineTime 0 Time 1 Time 2 Time 3 Time 4 Time 5 Time 6 Time 7TimePotentiometer(1 kohm, 1/2W)ShieldVRV1Power supply forspeed signal:+ 11V, 10mASpeed signal input:0 ~ 10V30BAXAAXCM1M2M1P1-CMP2-CMONONON ON ONONTimeTimeSpeed signal Input 2I5GSpeed signal input:4 ~20mA (250ohm)Common forVR, V1, IP3-CMFX-CMONONTimeTime[Wiring to By-Pass Motor to Commercial line][Multi-Accel/Decel Time Operation]Related Functions:I/O-25 ~ I/O-38 [1 st ~7 th Accel/Decel Time]122