Manual - Famco

Chapter 6 - Parameter Description [EXT]EXT-22 ~ EXT-23: Gains for ‘Sub-B’ BoardFactory Default: 3000 3000EXT► PG P-gain22 3000223000This is the proportional gain when the EXT-14 is set to‘Feed-back’.Factory Default: 50 50EXT-27: + Torque LimitEXT► Trq + Limit27 180 %This is the Forward Torque Limit when the control modeis set to ‘Sensored Vector_SPD’.EXT-28: - Torque Limit27180Factory Default: 180 % 180EXT► PG I-gain23 50 2350EXT► Trq - Limit28 180 %28180This is the integral gain when the EXT-14 is set to ‘Feedback’.EXT-24: Slip Frequency for ‘Sub-B’ BoardFactory Default: 100 % 100EXT►PG Slip Freq24 100 %24This is the limit frequency the inverter uses tocompensate the motor speed drop due to loadfluctuation. The set point value is the percentage ofFUN-32 [Rated Motor Slip].EXT-25: Sensored Vector_SPD PEXT► ASR P-Gain25 100 %25This is the proportional gain when the control mode isset to ‘Sensored Vector_SPD’.Adjust the gain when the speed and torque response isslow.EXT-26: Sensored Vector_SPD I100Factory Default: 100 % 100EXT► ASR I-Gain26 200ms26100200Factory Default: 200ms 200This is the integral gain when the control mode is set to‘Sensored Vector_SPD’.Adjust the gain when the speed and torque response isslow.Factory Default: 180 % 180This is the Reverse Torque Limit when the control modeis set to ‘Sensored Vector_SPD’.EXT-30 ~ EXT-32: Multi-Function OutputTerminal (Q1, Q2, Q3) Define – Sub-A, Sub-CQ1, Q2, Q3 terminals are provided on Sub-A and Sub-Cboard as an open collector output. The functions ofthese terminals can be selected the same as I/O-44[Multi-function Auxiliary Contact Output Define].EXT► Q1 define30 FDT-130Factory Default: FDT-1 0EXT► Q2 define31 FDT-231Factory Default: FDT-2 1Factory Default: FDT-3 2Related Functions:FU1-54 [Overload Warning Level]FU1-55 [Overload Warning Time]FU1-59 [Stall Prevention Mode]FU1-60 [Stall Prevention Level]I/O-12 ~ I/O-14 [Multi-function InputTerminal define]I/O-42 ~ I/O-43 [Frequency Detection]I/O-44 [Multi-function Auxiliary ContactOutput define]I/O-50 ~ I/O-56 [Auto Operation]01140