Manual - Famco

CHAPTER 1 -INSTALLATION1.1 Inspection• Inspect the inverter for any damage that may have occurred during shipping.• Check the nameplate on the inverter. Verify the inverter unit is the correct one for the application. The numberingsystem for the inverter is as shown below.SV 008 iS5 2 XXX U(480)LS Inverter Motor Capacity Series Name Input Voltage008: 1 HP 075: 10 HP 2: 200 ~ 230V (±10%) (50/60Hz)015: 2 HP 110: 15 HP 4: 380 ~ 460V (±10%) (50/60Hz) UL Listed022: 3 HP 150: 20 HP 4: 380 ~ 480V(±10%) (50/60Hz)037: 5 HP 185: 25 HP055: 7.5 HP 220: 30 HP N: Without KeypadO/E: UL Open/Enclosed Type 1DB: Built-in DB Unit1.2 Environmental Conditions• Verify ambient condition for the mounting location.- Ambient temperature should not be below 14ºF (-10ºC) or exceed 104ºF (40ºC).- Relative humidity should be less than 90% (non-condensing).- Altitude should be below 3,300ft (1,000m).• Do not mount the inverter in direct sunlight and isolate it from excessive vibration.• If the inverter is going to be installed in an environment with high probability of penetration of dust, it must belocated inside watertight electrical boxes, in order to get the suitable IP degree.1.3 Mounting…• The inverter must be mounted vertically with sufficient horizontal and vertical space between adjacent equipment(A= Over 100mm, B= Over 50mm). However, A= Over 500mm and B= 200mm should be obtained forinverters with 40Hp and above.ABBA6