Manual - Famco

APPENDIX A - FUNCTIONS BASED ON USESet the function properly according to the load and operating conditions. Application and related functions are listed inthe following table.UseRelated Parameter CodeAccel/Decel Time, Pattern AdjustmentDRV-01 [Acceleration Time], DRV-02 [Deceleration Time],FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]Reverse Rotation PreventionFU1-03 [Forward, Reverse Prevention]Minimum Accel/Decel TimeFU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]Accel/Decel at Continuous Rating Range FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]Braking Operation AdjustmentFU1-07 [Stop Method], FU1-08~11 [DC Braking],FU1-12~13 [DC braking at start]FU1-20 [Maximum Frequency],Operations for Frequencies Over 60 HzFU1-25 [Frequency Upper Limit],I/O-05 [Frequency Corresponding to Max. Voltage of V1],I/O-10 [Frequency Corresponding to Max. Current of I]Selecting an Appropriate OutputCharacteristics for the LoadFU1-20 [Maximum Frequency],FU1-21 [Base Frequency]FU1-22 [Starting Frequency],Motor Output Torque AdjustmentFU1-26~28 [Torque Boost],FU1-59~60 [Stall Prevention],FU2-30 [Rated Motor]Output Frequency LimitFU1-23~25 [Frequency Upper/Lower Limit],I/O-01~10 [Analog Frequency Setting]Motor Overheat ProtectionFU1-50~53 [Electronic Thermal], FU2-30 [Rated Motor]I/O-12~14 [Define the Multi Function Input Terminals],Multi Step OperationI/O-20~27 [Jog, Multi Step Frequency],FU1-23~25 [Frequency Upper/Lower Limit]Jog OperationI/O-20 [Jog Frequency]Frequency Jump OperationFU2-10~16 [Frequency Jump]Timing the Electronic Brake OperationI/O-42~43 [Frequency Detection Level],I/O-44 [Multi Function Output]Displaying the Rotating SpeedDRV-04 [Motor Speed],FU2-74 [Motor RPM Display Gain]Function Alteration PreventionFU2-94 [Parameter Lock]Energy SavingFU1-39 [Energy Saving]Auto Restart Operation After Alarm Stop FU2-27~28 [Auto Retry]2 nd Motor Operation FU2-81~90 [2 nd Function]PID Feedback OperationFU2-50~54 [PID Operation]Frequency Reference Signal and Output I/O-01~10 [Analog Frequency Setting]AdjustingDefine the Multi-Function Input Terminals I/O-12~14 [Define the Multi-Function Input Terminals]Define the Multi-Function Input Terminals I/O-44 [Multi Function Auxiliary Contact Output Setting]Commercial Line ⇔ inverter SwitchoverOperationI/O-12~14 [Define the Multi-Function Input Terminals],I/O-44 [Multi-Function Auxiliary Contact Output Setting]Frequency Meter CalibrationI/O-40~41 [FM Output]I/O-46 [Inverter No.],Operate by Communicating with a Computer I/O-47 [communication Speed],I/O-48~49 [Loss of Reference]189