Manual - Famco

Chapter 2 - Operation2.5.2 Operation via Control TerminalSetting:DRV-03 [Drive Mode (Run/Stop method)] = 1 (Fx/Rx-1)DRV-04 [Frequency Mode (Freq. setting method)] = 2 (V1)1. Check the LCD display when Power ON. Otherwise, change the setting indicated above.DRV▶T/V 0.0 A00 STP 0.00Hz2. Turn the FX (or RX) terminal ON. Then FWD (or REV) LED will be lit.DRV▶T/V 0.0 A00 FWD 0.00Hz3. Set the frequency using V1 (Potentiometer). Output freq (60Hz)., Rotating direction (FWD or REV) and outputcurrent (5A) will be displayed on the LCD.DRV▶T/V 5.0 A00 FWD 60.00Hz4. Output freq value is decreasing when turning the potentiometer counterclockwise. Inverter output stops at 0.00Hzand motor is stopped.DRV▶T/V 0.0 A00 FWD 0.00Hz5. Turn FX (or RX) terminal OFF.DRV▶T/V 0.0 A00 STP 0.00Hz35