Manual - Famco

Chapter 6 - Parameter Description [APP]APP-30: Feedback Freq. / Percentage DisplayAPP► Fbk/PER30 [Hz]/[%]300.00Factory Default: - 0.00operation. For example, when Reference Frequency(DRV-00) is set to ‘30Hz’, Draw Mode (APP-33) to‘V1_Draw’ and Draw Size (APP-33) to ‘10%’, thefrequency difference during Draw operation is between27 Hz and 33Hz. The following figure shows the blockdiagram for Draw and Override operation.This code displays the feedback value using on PIDcontroller in Hz or %.APP-31: Actual Value Display in PercentageAPP► Prs31 [Bar]/[Pa]310Factory Default: - 0This code displays the value using on PID controller inpercentage.APP-32: Pressure Display ScaleAPP► Scale Disp32 1000321000Factory Default: 1000 1000This parameter adjusts APP-31.APP-33: Draw Mode SelectionAPP► Draw Mode33 None330Factory Default: None 0This code sets the signal input to use for Draw operation.The main reference frequency is set in DRV-04. Thisparameter should be set to a signal that is not selectedin DRV-04.APP-34: Draw Size SettingAPP► Draw Perc34 100 %34100Factory Default: 100% 100This code sets the frequency bandwidth during Draw151