Manual - Famco

Chapter 5 - Parameter ListCodeDescriptionKeypad DisplaySetting RangeLCD 7-Segment LCD 7-SegmentUnitsFactoryDefaultFU2-44 Rotor Time Constant Tr 44 0 to (depend on FU2-30) [mS] NoFU2-45FU2-46P Gain for SensorlessControlI Gain for SensorlessControlFU2-47 PID Operation Selection Proc PI mode 47Adj.DuringRunSL P-gain 45 0 to 32767 1 1000 Yes 109SL I-gain 46 0 to 32767 1 100 Yes 109No 0Yes 1Page- No No 110FU2-48 23 PID F Gain PID F-gain 48 0 to 999.9 [%] 0.1 0 [%] YesFU2-49FU2-50FU2-51PID Auxiliary ReferenceMode SelectionPID Output DirectionSelectionPID Feedback SignalSelectionAux Ref Mode 49None 0Keypad-1 1Keypad-2 2V1 3I 4V2 5- None NoPID Out Dir 50 Target freq. 0 - Target freq. NoPID F/B 51I 0V1 1V2 2- I NoFU2-52 P Gain for PID Control PID P-gain 52 0 to 999.9 [%] 0.1 1.0 [%] YesFU2-53 I Gain for PID Control PID I-time 53 0 to 32.0 [sec] 0.1 10.0 [sec] YesFU2-54 D Gain for PID Control PID D-time 54 0 to 1000 [msec] 0.1 0.0 [msec] YesFU2-55FU2-56High Limit Frequency forPID ControlLow Limit Frequency forPID ControlFU2-57 PID Output Inversion PID Out Inv. 57PID limit-H 55 0 to 300.00 [Hz] 0.01 60.00 [Hz] YesPID limit-L 56 0 to 300.00 [Hz] 0.01 0.00 [Hz] YesNo 0Yes 1- No NoFU2-58 PID Output Scale PID Out Scale 58 0.1 to 999.9 [%] 0.1 100 [%] NoFU2-59 PID P2 Gain PID P2-gain 59 0 to 999.9 [%] 0.1 100 [%] NoFU2-60 P Gain Scale P-gain Scale 60 0 to 100 [%] 0.1 100 [%] NoFU2-69FU2-70Accel/Decel ChangeFrequencyReference Frequency forAccel and DecelAcc/Dec ch F 69 0 to FU1-20 0.00 [Hz] No 114Acc/Dec freq 70FU2-71 Accel/Decel Time Scale Time scale 71Max freq 0Delta freq 10.01 [sec] 00.1 [sec] 11 [sec] 2110110111- Max freq No 1140.01 0.1 [sec] Yes 114FU2-72 Power On Display PowerOn disp 72 0 to 12 1 0 Yes 114FU2-73 User Display Selection User disp 73FU2-74Gain for Motor SpeedDisplayVoltage 0Watt 1- Voltage Yes 115RPM factor 74 1 to 1000 [%] 1 100 [%] Yes 11523Code FU2-48 through FU2-62 appears only when FU2-47 is set to ‘Yes’.62