Manual - Famco

Chapter 2 - Operation2.5 Operating Example2.5.1 Operation via Control terminal + KeypadSetting: DRV-03 [Drive Mode (Run/Stop method)] = 1 (Fx/Rx-1)DRV-04 [Frequency Mode (Freq. setting method)] = 0 (Keypad-1)• With above setting, Freq setting via terminal & Run/Stop via Keypad disabled1. Check the LCD display when Power ON. Otherwise, change the setting indicated above.DRV▶T/K 0.0 A00 STP 0.00Hz2. Turn the FX (or RX) terminal ON. Then FWD (or REV) LED will be lit.DRV▶T/K 0.0 A00 FWD 0.00Hz3. When setting the Ref. Freq to 60 Hz using PROG/ENT/SHIFT, ▲ keys, motor will rotate at 60Hz.FWD (or REV) LED will be flickering during Acceleration/ Deceleration.DRV▶ Cmd. freq00 0.00HzDRV▶ Cmd. freq00 60.00HzDRV▶T/K 5.0 A00 FWD 60.00Hz4. Turn Fx (or Rx) terminal Off. Then Stop LED will be lit.DRV▶T/K 0.0 A00 STP 60.00HzNote) To enable Run/Stop via keypad & Freq setting via control terminal…Setting: DRV-03 [Drive Mode (Run/Stop method)] = 0 (Keypad)DRV-04 [Frequency Mode (Freq. setting method)] = 2 (V1)33