Manual - Famco

Chapter 6 - Parameter Description [DRV]Code Keypad Display Parameter NameI/O-01I/O-02I/O-03V1 filterV1 volt x1V1 freq y1Filter Time Constant for V1Signal InputV1 InputMinimum VoltageFrequency Corresponding toV1 Input Minimum VoltageI/O-04 V1 volt x2 V1 Input Maximum VoltageI/O-05V1 freq y2Frequency Corresponding to V1Input Maximum VoltageCode Keypad display Parameter NameI/O-06 I filterFilter time constant for I signalInputI/O-07 I curr x1 I Input Minimum CurrentI/O-08 I freq y1Frequency Corresponding to IInput Minimum CurrentI/O-09 I curr x2 I Input Maximum CurrentI/O-10 I freq y2Frequency Corresponding to IInput Maximum Currentè Important: Increase I/O-06-[Filter time constant for Isignal Input] if the I signal is affected by noise causingunstable operation. Increasing this value makesresponse time slower.è Important: Increase I/O-01-[Filter Time Constant for V1Signal Input] if the V1 signal is affected by noise causingunstable operation. Increasing this value makesresponse time slower.Set freqI/O-10Set freq.I/O-05I/O-08Terminal I ( 0 ~ 20 mA )I/O-03V1 analog input (0~10V)I/O-07I MinimumcurrentI/O-09I MaximumcurrentI/O-02V1 Minimum VI/O-04V1 Maximum VI/O-06~10 [Analog Current Input “ I “ Signal adjustment]• Command Freq/Torque setting via “I” input terminalwhen set DRV-04 [Frequency/Torque mode] to 3 (I)or 4 (V1+I)Related Functions:DRV-04 [Frequency or Torque Mode]DRV-16 [Speed Unit Selection]FU1-20 [Maximum Frequency]FU2-39 [Control Mode Selection]I/O-1~10 [Analog FrequencyCommand/Torque]Code Default setting Setting rangeI/O-06 10 [msec] 0 ~ 10000 [msec]I/O-07 4 [mA] 0 ~ 20 [mA]I/O-08 0 [Hz] 0 ~ Max. freqI/O-09 20 [mA] 0 ~ 20 [mA]I/O-10 60 [Hz] 0 ~ Max. freqDRV-01: Acceleration TimeDRV► Acc. time01 20.0 sec0120.0Factory Default: 20.0 sec 20.080