Manual - Famco

Chapter 4 – Quick start procedures4.2 Operation using Control Terminals1. Install a potentiometer on terminalsV1, VR, 5G and connect wiring asshown below.1 kΩ, 1/2 WLCD Display7-Segment DisplayP1 P2 P3 FX RX NC VR VIJOG CM CM BX RST I FM 5G2. Apply AC power.3. Confirm that the DRV 03 is set at‘Fx/Rx-1’.4. LCD: Press [▲] key to move DRV 04.7-Seg: Rotate encoder knob until ‘04’is displayed.5. LCD: Press [PROG] key.7-Seg: Press [PROG/ENT] key.6. LCD: Press [▲] key and set at ‘V1’.7-Seg: Rotate encoder knob and setat ‘2’.7. LCD: Press [ENT] key.7-Seg: Press [PROG/ENT] key.8. Press [SHIFT/ESC] key.9. Set the frequency by rotating thepotentiometer.DRV►T/K 0.0 A00 STP 0.00HzDRV► Drive mode03 Fx/Rx-1DRV► Freq mode04 Keypad-1DRV► Freq mode04 Keypad-1DRV► Freq mode04 V1DRV► Freq mode04 V1DRV►T/V 0.0 A00 STP 0.00HzDRV►T/V 0.0 A00 STP 60.00HzThe DRV LED is ON.The PROG/ENT LED is turned ON.The PROG/ENT LED is turned ON.The PROG/ENT LED is turned OFF.10. Close the FX or RX contact to run themotor.11. Open the FX or RX contact to stop themotor.The FWD or REV LED starts blinking.The STOP/RESET LED starts blinking.The RUN LED starts blinking.The STOP/RESET LED starts blinking.53