Manual - Famco

Chapter 6 - Parameter Description [DRV]☞ Note: There are WDOG error, EEP error, and ADCOffset for the inverter Hardware Fault - the inverter willnot reset when H/W fault occurs. Repair the fault beforeturning on the power.☞ Note: Only the highest-level fault will be displayed whenmultiple faults occur.Related Functions: FU2-01 to FU2-05 [Previous Fault History]FU2-06 [Erase Fault History]• FU2-01 to FU2-05: There are up to 5 faults saved.• FU2-06: Erases the faults saved in FU2-01 to FU2-05.DRV-13: Motor Direction Set (7-SegmentKeypad)This code sets the motor direction when using the 7-Segment keypad.7-Segment DisplayDescription0 Run to forward direction1 Run to reverse directionDRV-14: Command/Output Frequency Display(LCD Keypad)This code shows the Command (Target) Frequency setin DRV00 and inverter Output Frequency.DRV-15: Reference/Feedback Frequency Display(LCD Keypad)13Factory Default: 0DRV►TAR 0.00Hz14 OUT 0.00HzFactory Default:0.00HzDRV►REF 0.00Hz15 FBK 0.00Hz0DRV-16: Speed Unit SelectionDRV► Hz/Rpm Disp16 HzSet this parameter to 0 [Hz] to display frequency, or to1[Rpm] to display speed.Related Functions: Changing the Hz/Rpm display affects thefollowing parameter display.• DRV-00, 05, 06, 07, 14• FU1-20, 21,22, 24, 25, 32• FU2-32• I/O-03, 05, 08, 10, 20, 21, 22, 23, 24, 42, 43• EXT-08, 10DRV-20: FU1 Group Selection(7-Segment keypad)DRV-21: FU2 Group Selection(7-Segment keypad)DRV-22: I/O Group Selection(7-Segment keypad)DRV-23: EXT Group Selection(7-Segment keypad)DRV-24: COM Group Selection(7-Segment keypad)DRV-25: APP Group Selection(7-Segment keypad)Select the desired group and press the PROG/ENT keyto move into the desired group. The parameter in thegroup can be read and written after moving into thedesired group.16Factory Default: Hz Hz0Factory Default:0.00HzThis code shows the Reference Frequency andFeedback Frequency while PID operation.This code appears only when ‘PID’ is selected in FU2-47.85