Manual - Famco

Chapter 6 - Parameter Description [FU2]Input PowerPower OnOutput FrequencyTrippedOutput FrequencyTimeTimeNo EffectStartNo EffectStartTimeFX-CMRST-CMONONONTimeTimeFX-CMONONTime[Reset restart: ‘No’][Power ON Start: ‘No’]Output FrequencyTrippedInput PowerPower OnOutput FrequencyTimeStartTimeFX-CMONTimeStartTimeRST-CMON[Reset restart: ‘Yes’]TimeFX-CMON[Power ON Start: ‘Yes’]☞ Note: In case of using ‘Power ON Start’ to ‘Yes’, makesure to utilize appropriate warning notices to minimize thepotential for injury or equipment damage.Related Functions:FU2-21: Restart After Fault ResetFU2► RST restart21 --- No ---FU2-22 ~ FU2-25 [Speed Search]TimeIf FU2-21 is set to ‘Yes’, inverter will restart after theRST (reset) terminal has been reset a fault.If FU2-21 is set to ‘No’, restart the inverter by cycling theFX or RX terminal to CM terminal after the fault hasbeen reset. If the motor is rotating by inertia at the timepower is restored, the inverter may trip. To avoid this trip,use ‘Speed Search’ function by setting FU2-22 to ‘xx1x’.21Factory Default: No 00☞ Note: In case of using ‘Reset Restart’ to ‘Yes’, make sureto utilize appropriate warning notices to minimize thepotential for injury or equipment damage.Related Functions:FU2-22: Speed Search Selection (Bit Set)FU2-23: Current Limit Level During SpeedSearchFU2-24: P Gain During Speed SearchFU2-25: I Gain During Speed SearchFU2►Speed Search22 0000FU2-22 ~ FU2-25 [Speed Search]220000Factory Default: 0000 0000FU2► SS Sup-Curr23 150 %23150Factory Default: 150 % 150102