Manual - Famco

Chapter 1 – Installation1.8 Control TerminalsP1 P2 P3 FX RX NC VR V130A 30C 30B AXA AXC JOG CM CM BX RST I FM 5GInput signalOutput signalType Symbol Name DescriptionStarting Contact Function SelectAnalog frequency settingAnalogContactP1, P2, P3Multi-Function Input1, 2, 3Used for Multi-Function Input Terminal.(Factory default is set to “Multi-Step Frequency 1, 2, 3”.)FX Forward Run Command Forward Run When Closed and Stopped When Open.RX Reverse Run Command Reverse Run When Closed and Stopped When Open.JOGBXJog FrequencyReferenceEmergency StopRuns at Jog Frequency when the Jog Signal is ON. The Direction is set bythe FX (or RX) Signal.When the BX Signal is ON the Output of the Inverter is Turned Off. WhenMotor uses an Electrical Brake to Stop, BX is used to Turn Off the OutputSignal. When BX Signal is OFF (Not Turned Off by Latching) and FX Signal(or RX Signal) is ON, Motor continues to Run.RST Fault Reset Used for Fault Reset.CM Sequence Common Common Terminal for Contact Inputs.NC - Not Used.VRV1I5GFM30A30C30BAXA, AXCFrequency Setting Power(+12V)Frequency Reference(Voltage)Frequency Reference(Current)Frequency SettingCommon TerminalAnalog Output (0~12V)(For External Monitoring)Fault Contact OutputMulti-Function OutputRelay* Tightening torque of control terminal blocksTER 1 – 140 Kgf·cm/(93.5 in-lb) TER 2 – 8 Kgf·cm/(5.3 in-lb)Used as Power for Analog Frequency Setting. Maximum Output is +12V,100mA.Used for 0-10V Input Frequency Reference. Input Resistance is 20 KΩ.Used for 4-20mA Input Frequency Reference. Input Resistance is 250 Ω.Common Terminal for Analog Frequency Reference Signal and FM (ForMonitoring).Outputs One of the Following: Output Frequency, Output Current, OutputVoltage, DC Link Voltage, and Torque. Default is set to Output Frequency.Maximum Output Voltage and Output Current are 0-12V and 1mA, 500Hz.Activates when Protective Function is Operating. AC250V, 1A or less;DC30V, 1A or less.Fault: 30A-30C Closed (30B-30C Open)Normal: 30B-30C Closed (30A-30C Open)Use After Defining Multi-Function Output Terminal. AC250V, 1A or less;DC30V, 1A or less.19