Manual - Famco

Chapter 4 – Quick start procedures4.3.2 Frequency set by Keypad and Run/Stop by External Source.1. Connect wiring as shown below.LCD Display7-Segment DisplayP1 P2 P3 FX RX NC VR VIJOG CM CM BX RST I FM 5G2. Apply AC power.3. Confirm that the DRV 03 is set at ‘Fx/Rx-1’.4. Confirm that the DRV 04 is set at‘Keypad-1’.DRV►T/K 0.0 A00 STP 0.00HzDRV► Drive mode03 Fx/Rx-1DRV► Freq mode04 Keypad-1The DRV LED is ON.5. Press [SHIFT/ESC] key.DRV►T/K 0.0 A00 STP 0.00Hz6. LCD: Press [PROG] key.7-Seg: Press [PROG/ENT] key.DRV► Cmd. freq00 0.00HzThe PROG/ENT LED is turned ON.7. LCD: Set the frequency using [SHIFT/ESC]and [▲] key.7-Seg: Set the frequency by rotating theencoder knob.8. LCD: Press [ENT] key to save the data.7-Seg: Press [PROG/ENT] key to save thedata.DRV► Cmd. freq00 60.00HzDRV►T/V 0.0 A00 STP 60.00HzThe PROG/ENT LED is turned ON.9. Close the FX or RX contact to run the motor.10. Open the FX or RX contact to stop themotor.The FWD or REV LED starts blinking.The FWD or REV LED starts blinking.The RUN LED starts blinking.The RUN LED starts blinking.55