3Designing with NevoStudio Pro

Working with Nevo Wireless Programming of Nevo S70
To start a Nevo S70 connection:
1. Verify that Enable Wireless Programming on the Tools menu is checked.
2. On the Home Page of Home Control in NevoS70 , press and hold the
Home Page hard key until NevoS70 beeps twice.
Once NevoStudio Pro recognizes the connection, the following dialog
appears:
Installer Tip: If you are unable to connect, verify that the wireless adapter is
the preferred adapter by selecting Tools|Manage Nevo Network
Settings...
3. Give the connected Nevo S70 a friendly name.
Installer Tip: Consider including the client’s last name and the room in
which they plan to use this Nevo S70 in the friendly name. You may
have several Nevo S70 s in your workshop at one time, and this will
make it easier to identify the correct one.
4. Check Automatically connect to this client if you don’t want to see this
dialog each time you connect this NevoS70 to your network.
Installer Tip: This dialog will only appear if NevoStudio Pro has focus and
no other wizard or dialog is active. Therefore if you want to use
wireless programming, you will want to check Automatically
connect to this client to facilitate reconnecting while running a
wizard.
NevoStudio Pro Design Guide 137