3Designing with NevoStudio Pro

Configuring Nevo Ecosystems Add Ecosystem Devices
Icon Meaning
• Review these general problem areas if you are sure that NevoLink has
obtained a valid IP Address. Normally you can do this by reviewing the
DHCP client list on the DHCP Server.
• Review the settings you made in “Step Two: Managing your Nevo
Network Settings” on page 138.
• On the computer, there may be another software product running
which uses the system's broadcast port and stops NevoStudio Pro
from discovering NevoLinks.
Add Ecosystem Devices
• Active NevoLink with ! and a MAC
Address or friendly name: The device was
identified correctly, but the connection
could not be established because the
device was busy during the discovery time.
To resolve this, initiate another discovery
using the Refresh tool on the Nevo
Ecosystem tab toolbar.
Installer Tip: Multiple active network
adapters are supported. You may need
to specify the preferred network
adapter using using Tools|Manage
Nevo Network Settings. See “Setting
General Wireless Network Options” on
page 147 for more information.
• NevoLink firmware update available: The
NevoLink is using an older firmware
version and should be upgraded.
You can add ecosystem devices using the wizard. This allows you to add the
device as a placeholder and then connect the device(s) to the ecosytem when
you are setting up the components at the job site.
Use the wizard to add:
• NevoLinks
• NevoConnect
• Z-Wave devices
• 3rd party IP devices (such as cameras) that may not be auto-discovered
NevoStudio Pro Design Guide 171