3Designing with NevoStudio Pro

Configuring Nevo Ecosystems Add Ecosystem Devices
6. Configure the system
For NevoConnect NC-50s, select the devices to associate to each port. .
For Z-Wave devices, select the device(s) you want to assign.
• If ID type is IP address, enter IP address
• If ID type is MAC address, enter MAC address
• If ID type is Z-wave, add a node by pressing the add node button
then the program button on the device within 30 seconds
7. Add UC
8. If IP device that supports Z-wave, add node. Stefanie: move to z-wave
section to add node: press add node button, then press program button
on device w/in 30 seconds.
Defining a Static Update Controller
This can be done during the Add Device Wizard, or by clicking (X) in the
Nevo Ecosytem tab.
Removing Nodes
Installer Tip: If you attempt to remove the Static Update Controller, a
warning dialog will appear.
1. Press remove node
2. Press the program button on the device
Configuring a Primary controller
:
Using the
NevoStudio Pro Design Guide 173