3Designing with NevoStudio Pro

Designing with NevoStudio Pro Working with Devices
navigation keys on Nevo to select a different page of buttons and use
one of those as the test function.
• If the device responds as expected, press the function key labeled
Select.
• If the device does not respond, either try a different key or press the
function key labeled Next to test the next device code.
Installer Tip: After you select a device code, before you reconnect to the
computer, you have the option to Learn (and Test) additional
functions. Use the function keys to enter these modes.
9. Once you have identified a device code by pressing Select, reconnect
Nevo to the NevoStudio Pro computer and press the function labeled
OK. Nevo uploads the identified code to NevoStudio Pro, then deletes
the downloaded test codes from Nevo.
10. Press Learn to learn additional functions.
11. On NevoStudio Pro, click Next. NevoStudio Pro confirms a successful
upload. Click Next again
12. Proceed to “Step 3: Completing the Wizard” on page 53
Step 2 Option D: Adding Devices by Entering the Device Code
1. Start the Add Device Wizard, then choose Add IR Device and click Next.
NevoStudio Pro Design Guide 47