3Designing with NevoStudio Pro

Designing with NevoStudio Pro Working with Projects
Installer Tip: The configurations are grouped in the list according to the
type of controller. Nevo Q50 configurations will appear above
Nevo S70 configurations in the list.
8. Click Finish.
NevoStudio Pro closes this wizard and starts the Add Device wizard.
(See “Working with Devices” on page 41.) Clear the checkbox to bypass
the Add Device Wizard and open the new Job window.
Working with Projects
A configuration contains the interface that your clients will see when they
start Nevo. You can create and modify any configuration within NevoStudio
Pro.
Creating a Configuration
You can add configurations when you create a new job, or you can add them
individually later.
To create a new configuration:
1. Use one of the following methods:
• Click File|Add Configuration|New Nevo Q50 Configuration
• Click File|Add Configuration|New Nevo S70 Configuration
• Right-click on the job name and select Add Configuration|New
NevoQ50 Project.
• Right-click on the job name and select Add Project|New Nevo S70
Project.
NevoStudio Pro adds an empty configuration at the bottom of the job
tree.
The first page that appears in the Job View tree under a specific controller
is the Home Page. This is the first page that appears on Nevo when a user
turns the unit on or selects Home. Use this page to design the initial
NevoStudio Pro Design Guide 33