3Designing with NevoStudio Pro

Add Ecosystem Devices Configuring Nevo Ecosystems
On-Device Ecosystem Setup
NevoConnect NC-50 serves as a Static Controller and should be selected as
the Static Update Controller by the Primary Controller. NevoConnect NC-
50 cannot act as a Primary Controller. The following are processes that
require input directly at NevoConnect:
• Being Added to or Removed from a network, also referred to as the
inclusion/exclusion process
• Creating a new Primary Controller
• Soft Resets
• Hardware Factory Reset
Step 1: Starting the On-Device Ecosystem Setup Wizard
To set up Ecosystem devices:
1. Press Advanced on the controller settings menu.
2. Select the Z-Wave icon
3. Press Configure.
This starts the On-Device Ecosystem Setup Wizard.
Step 2: Configuring the Ecosystem
Different configuration options are available depending on the type of
controller you are using.
Installer Tip: When adding and removing nodes with controllers you must
position the controller within five inches of the target node. This
avoids accidentally modifying a node other than the intended device.
Each configuration can have a single Primary Controller that can add or
remove nodes from Z-Wave networks. There are five primary controller
configuration options on the Ecosystem Setup Wizard:
• Add Node to Network (See “Step 2 Option A: Add Node to Network” on
page 175.step 2 option A)
• Remove Node from Network (See “Step 2 Option B: Remove Node from
Network” on page 177.)
• Make New Primary (See “Step 2 Option C: Make New Primary” on
page 178.)
• Define Static Update Controller (See “Step 2 Option D: Define Static
Update Controller (UC)” on page 178.)
• Factory Reset (See “Step 2 Option E: Factory Reset” on page 179.)
174 NevoStudio Pro Design Guide